Easy DIY Dog Bed

Photo: Laurey W. Glenn
Start with a ready-made dog pillow and discarded shipping pallets (found free behind commercial buildings—just ask before taking) to build your puppy his own custom bed.   

Materials/Tools Needed:

2 wooden pallets
Reciprocating saw (optional)
Table saw or handsaw
Deck screws
Electric drill/screwdriver
4 trim mold pieces bought from the hardware store and cut to the measurements of the dog bed. We used two (8 foot by 1/2 inch by 3/4 inch) pieces for the top edge and two (8 foot by 3/4 inch by 3/4 inch) pieces for the bottom edge.
Miter saw
Finishing nails
1 quart satin-finish paint

How To Build the Bed

1. Dismantle the pallets. You can just use a hammer to separate the boards, but for faster results, use a reciprocating saw to cut through the nails.

2. Cut 2 by 4 pallet pieces to length with a table saw or handsaw. Then build a box, attaching the sides to each other with deck screws. Note: The inside measurement of the box should correspond to the dimensions of the dog pillow.

3. Attach six pallet slats, evenly spaced, with deck screws on underside of box.

4. Cut trim pieces with miter saw (optional). Attach with finishing nails around the top and bottom edges of the bed.

5. Cut feet from leftover 2 by 4 pallet pieces, and attach with deck screws.

6. Caulk any gaps, and then sand and paint.

DownComment IconEmail IconFacebook IconGoogle Plus IconGrid IconInstagram IconLinkedin IconList IconMenu IconMinus IconPinterest IconPlus IconRss IconSave IconSearch IconShare IconShopping Cart IconSpeech BubbleSnapchat IconTumblr IconTwitter IconWhatsapp IconYoutube Icon